---

A two pack high build epoxy Polyamide based under coat containing inert pigments. It is recommended as a final coat in an Epoxy system

Characteristics

• High build in single coat.
• Excellent resistance to fresh and salt water
• Abrasion resistance and flexible films.
• Excellent inter-coat adhesion.
• Resistant to solvents.
• Resistance to mild acids.

Uses

Coating for long term protection for structural steel, concrete surface and internal lining of edible oil tanks, and fuel tanks. Suitable for marine installations, power plants, fertilizers, hospitals, laboratories, etc.

Description :

Application & Reduction:

Tollens Epoxy Primer can be brushed, rolled or sprayed. . Use where application temperature can be proceed above 4 ° C

Application Method

Brush, Roller or Spray.

Surface preparation:

Epoxy top-coat is recommended as a final coat in an Epoxy system. Surface preparation is pre conditioned for an optimum performance of the system. The surface to be top coated must be free from all surface contaminates like dust, dirt grease or any other contaminates. If the previous epoxy coat is more than 15 days cured at 35oC, single coat of epoxy tie coat is recommended to achieve proper inter-coat adhesion.

Thinning (Volume)

10-15 % depending on the method of application.

Thinner

Tollens Epoxy Thinner

Airless Spray Requirements

Tip – 2200 PSI / 0.015" – 0.020"

Conv. Spray Requirements

Atomizing pressure: 40 PSI

Precautions:

• Use with adequate ventilation
• May cause eye, nose, and throat and skin irritation.
• Keep out of the reach of children
• Do not use in tank or pit without proper protection

Packing

Metal drums 5 US gallons

Shelf life @ 30 ° C

18months, in original sealed container, with proper storage.

System Recommended